Legacy - BK to B8000 cable Diagram

Legacy - BK23 Lead Wire Pinout Application Note - Pinout for BK motor (AKM23D) connection to B8000 series drives. (B8000 and BK23 combination is not recommended. Motor failure is likely to occur.)

Legacy - B8000 Motor Files for BK & AKM Motors - These are the default motor configuration files for the B8001 and B8501 drives. (Do NOT use the BK23 (AKM23D) motor with the B8000 Series drives. Motor failure is likely.)

T12 (IDC) Stepper Motor Wiring Application Note

Basic Motor Theory of Permanent Magnet DC Motors

Legacy - Quickset Software for IDC B8000 Series Servo Drives - Quickset is a revision of Servo Tuner that was made to run on Windows XP . It has not been tested on Windows 7.

DS6 Catalog Data Sheet

DS6 Roll Moment Deflection Calculator - Spreadsheet for calculating an estimated deflection based on a roll moment load

DS6 Deflection Spec Sheet - This shows the deflection a specific loading.

DS4 Series Positioning Tables User's Manual

DS4 Payload Calculator - Calculates travel life based on loading

DS4 Deflection Spec Sheet - This shows deflection at specific loads.

DS4 Limit Sensor with S300 Application Note - Explains how to connect the DS4 limit sensors with the S300/S600/S700 servo drives.

Legacy - The T-Series motors for IDC are a select few Pacific Scientific motors that were chosen to be standard options on IDC actuators and precision tables.

This article refers to G&L PiC application note document AN000047 and describes how to conver from a DSA to a MMC-SD Drive. Applies to the following Sheffield Automation servo amplifiers: Centurion™ Line DSA100 and MicroDSA servo amplifiers from Sheffield Automation and MMC-SD 230 and 460 VAC amplifiers.

Legacy - Servostar S and CD Velocity Tuning Application Note

Legacy - Servostar S and CD Velocity Control Application Note

Legacy - Servostar S and CD Terminal Emulation Application Note

Legacy - Servostar S and CD Sine Encoder Feedback Application Note

Legacy - Servostar S and CD Serial Communication Application Note