Warnsymbole, sichere Spannung auf 50V geändert, Europäische Richtlinien aktualisiert

This certification indicates that the S700 SERVOSTAR servo drive is in compliance.

This documentation file was updated on 3/29/2016 for Pic900 controller hardware.

EU-Konformitätserklärung fur PMX Schrittmottor 23 oder 34.

EU-Konformitätserklärung fur PMX schrittmotor.

EU Declaration of Conformity for PMX23, and PMX34 Stepper Motors.

EU Declaration of Conformity for PMX08, PMX11, PMX14, and PMX17 Stepper Motors

AKD Central Power Supply Firmware Motion Control with EtherCAT. Note: This firmware complies with recently revised U.S. and E.U. export regulations (E.U. Dual Use Regulation 428/2009, and U.S. Dual-use regulation EAR Category 3 under ECCN3A225).

AKD Near Servo Drive Firmware Motion Control with EtherCAT, dual line, and local safety. Note: This firmware complies with recently revised U.S. and E.U. export regulations (E.U. Dual Use Regulation 428/2009, and U.S. Dual-use regulation EAR Category 3 under ECCN3A225)

AKD Near Servo Drive Firmware Motion Control EtherCAT and single line. Note: This firmware complies with recently revised U.S. and E.U. export regulations (E.U. Dual Use Regulation 428/2009, and U.S. Dual-use regulation EAR Category 3 under ECCN3A225).

EU-Konformitätserklärung fur Kollmorgen Cartridge DDR

EU Declaration of Conformity for the Cartridge DDR C and CH Cartridge Series (Models C04, CH04, C05, CH05, C06, CH06, C09, CH09, C13, and CH13)

AKD PROFINET RT - Beschreibt die Installation, Inbetriebnahme, den Funktionsumfang und das Softwareprotokoll für AKD mit PROFINET RT. Gültig für Firmware-Version 1.14.

Safety Guide for Synchronous Servomotors for Direct Drives

Mounting / Installation guide for Cartridge DDR, Synchronous Servomotors for Direct Drives. Revision A, 03-2016.

Bugfix (control of external brake resistor)

Bugfix (control of external brake resistor)

Valid for KVB 2.10 Build 2.15.2029.0. This HMI program is set up to run motion tasks in the AKD drive. The operator can select from 5 motion tasks saved in the drive and run the selected task. The distance and speed of one other task can be edited by the operator. This program is also set up to run a manual jog move in velocity mode. For more information, see the application note included in this package.

Valid for KVB software 2.10 Build 2.15.2029.0. An HMI program that is setup to work with a Basic program in the AKD Basic drive. Allows the operator to select and execute five pre-programmed position moves saved in the Basic program. The operator can edit the distance and speed of one pre-programmed position move. Indicators show the status of motion. The HMI will indicate if homing is complete and the homing move can be started from the HMI.

A technical reference that covers the EtherCAT Library, System Library, Pipe Network and PLCopen Motion Library. For software version 2.10.