KAS IDE fails to load the ESI files from the ESI library and fails to add the EtherCAT devices to the project when the FIPS (Federal Information Process Standards) security policy is enabled on the computer.
This failure may be noticed when using…
AKD2G Dual Axis drives have the ability to use the new Gantry Command Source. When the Command Source is changed to 4 - Gantry, Axis2 will follow all commands sent to Axis1 (enable/disable and motion commands). This is meant to be used when there are…
The below video demonstrates how an EtherCAT network can be created with the KAS IDE software and the FSoE parameters can be automatically shared with a BBH Safety Controller. Also, Safety Risk Assessment (SRA) parameters setup in the AKD2G…
Hello everybody.
I've spend all the morning trying to download KAS IDE, but I didn't get.
Do you know where can I get KAS IDE?
I'm going to reprogram a Kollmorgen Servomotor driven by AKD-M01207-MCEC-0000 servodriver. I read that I…
Hello we are development a four axis machine, including its process control, the machine programing is development by 2 programmers,
one of them is creating motion control section and other one is doing process control section, we are…
I'm controlling my PCMM from a custom C# .NET Windows application which is also controlling some other hardware. I can currently communicate with the drive via http get/set requests. But what is the recommended method to communicate with the drive?…
I'd like to be able to select from the loaded cam profiles on the control panel, and remotely. Is there a way to populate a Combo-Droplist with the names of all loaded cam profiles? Or to get a list from a global variable?
The following table provides a resource for what firmware is associated with each release of the KAS IDE. This includes both firmware for the drive built into the AKD-PDMM controller, as well as the firmware for other drives that may be used within…
Home >
Knowledge Base >
Community >
Downloads >